wilux ELITE Manual De Instrucciones página 20

Istruzioni Elite 24-05-2004 10:14 Pagina 20
This function prevents from catching a cold, helps to eliminate toxins and to cure the
beauty of the skin. The display registers the selected duration and temperature until a
Steambath functions
When you activate the steambath the shower functions are inhibited.
ATTENTION:
VERIFY THAT THE CABIN DOOR IS CLOSED AND THAT THERE ARE NOT EXCESSIVE
LOSSES OF STEAM WHEN ACTIVATING THE STEAM BATH.
At the internal of the steamoutlet you can insert a piece of cotton drenched in essential
oils or other aromatic products. ATTENTION: do not obstruct the steam outlet with the
cotton. Do not use alcohol-based products.
Preparation of the cabin
Press the key
switched off. The corresponding led starts blinking; the displays will blink and will visualize
the temperature in the box. The steam generator will start blowing steam into the box until
the selected temperature will be achieved.
To program the desired temperature use the keys
starts the established temperature will be 30°C. Press the key
temperature of 40°C, the corresponding led will be illuminated. Within a short time the
temperature in the box will be increased up to 38°C-42°C.
Press the key
illuminated. Within 30-40 minutes the temperature will be increased up to 45°C-50°C. To
return to 30°C press the key @@.
If you press the key
the panel will be switched off; otherwise the temperature will be set at 30°C.
Now you can select the time of the treatment with the key @@, you can choose between
10, 20 and 30 minutes, pressing repeatedly the same key. When the selected temperature
will be achieved the spotlight starts blinking and you will hear an acoustic signal. The
display will visualize the selected temperature and time of treatment (which can still be
changed pressing the key @@).
How does the steam bath works
To start the steam bath press again the key @@. The spotlight stops blinking and the
acoustic signal will be extinguished. The countdown of the selected time will start and will
be visualized on the display; on the right display will be blinking the decimal separator.
Press the key
signal, this indicates that the cycle has been terminated. To repeat the cycle or to program
again the time of treatment press the key @@.
If you set a different time of treatment the steam bath will be activated automatically again after
10 seconds. On the contrary it will be interrupted and the shower functions can be activated.
situation of total wellness will be reache.
@@ to activate the steam generator. All the shower functions will be
@@ to achieve a temperature of 50°C, the corresponding led will be
@@ when the two leds referring to the keys
@@ to deactivate the steam bath. After 10 seconds you will hear an acoustic
20
@@+@@ . When the steam generator
@@ to achieve a
@@+@@ are not illuminated,