Dispense Liquid; Lock/Unlock The Pump Button; Cleaning, Care & Maintenance - Caterlite K711 Manual De Instrucciones

UK
1. Lift the latch to open the lid.
2. Fill the appliance with liquid. Do not fill above
the FULL line.
3. Close the lid, ensuring it locks firmly in place.
4. Plug in the power cord and connect it to the
mains power supply.
5. The BOILING indicator lights up and the
appliance begins to heat.
Note: The appliance will take
approximately 45 minutes to
heat up when filled with cold
water.
6. Once the correct temperature has been
reached, the WARMING indicator lights up
and the appliance is ready to dispense.
Warning: There is a danger of
scalding when opening the lid
during and after use. Take care
to avoid the expulsion of steam.

Dispense Liquid

There are 3 methods of dispensing liquid:
1. Hold a suitable receptacle beneath the spout.
2. Push the "POUR" button to dispense the liquid
or
Unlock the Pump button and push down
repeatedly to pump out the liquid
or
Press the receptacle against the switch behind
the spout.
Troubleshooting
If your Caterlite appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The unit is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Steam leaks from Seal worn
the seal
No water is When the water just gets
pumped out boiled, there is too much steam
accumulated inside the pot
4
K711_ML_A5_v3_20190925.indb 4
Reboil
It may be necessary to reheat the water in the
appliance.
•

Lock/Unlock the Pump Button

•
•
Cleaning, Care &
Maintenance
•
•
•
Probable Cause
Check the unit is plugged in correctly and switched on
Call Caterlite agent or qualified technician
Replace the plug fuse
Check power supply
Call Caterlite agent or qualified technician
Call Caterlite agent or qualified technician
Once temperature has been reached, please allow
several seconds for the pressures to equalise prior to
activating the pump
Press the REBOIL button to reboil the water.
Slide the lock to the CLOSED position to lock
the pump button.
Slide the lock to the OPEN position to unlock
the pump button
Always disconnect the appliance
from the power supply before
cleaning.
Use a damp cloth to clean the body and lid.
Dry thoroughly after cleaning.
Periodically descale the appliance with a
suitable descaling solution
Note: Always run water through
the appliance after descaling to
rinse the inner pot and tubes.
Discard the water after use.
Solution
2019/9/25 14:31