DeWalt DW892 Manual De Instrucciones página 5

Cizalla calibre 14
Ocultar thumbs Ver también para DW892:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

384417/DW892 .1
7/15/02
11:46 AM
• CHECK DAMAGED PARTS. Before further use of the tool, a
guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by authorized service
center. Do not use tool if switch does not turn it on and off.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Page 2
FIG. 1
LOCK
BUTTON
Thickness .1mm (.004")
Thickness .2mm (.008")
Thickness .3mm (.012")
2
PADDLE SWITCH
FIXED
BLADE
2/3 1/3
FIG. 3
THICKNESS
GAUGE
For 1mm plate thickness (.039" - 20 Gauge)
For 1.5mm plate thickness (.059" - 16 Gauge)
For 2mm plate thickness (.079" - 14 Gauge)
MOVING
BLADE
FIG. 2
C
B
A

Publicidad

Tabla de contenido
loading

Tabla de contenido