Safety Warnings - Remington GARDEN WIZARD 109312-01 Manual Del Propietário

Ocultar thumbs Ver también para GARDEN WIZARD 109312-01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRIC TILLER
SAFETY
WARNINGS
WARNING: When using elec-
tric gardening appliances, basic
safety precautions should always
be followed to reduce the risk of
fire, electric shock, and personal
injury.
WARNING: This product con-
tains chemicals known to the
State of California to cause can-
cer or birth defects, or other re-
productive harm.
READ ALL INSTRUCTIONS
BEFORE OPERATING TILLER
1. Do not operate tiller near underground
electric cables, telephone lines, pipes,
or hoses. If in doubt contact your util-
ity company to locate underground ser-
vices. You may also contact the Na-
tional One Call referral number, 1-888-
258-0808, for local contact information
concerning underground utilities.
2.
Watch what you are doing. Use com-
mon sense. Do not operate tiller when
you are tired.
3.
Only well-instructed adults should op-
erate tiller. Never allow children to op-
erate tiller.
4.
Do not use the tiller for any job except
that for which it is intended.
5.
Use only electrical voltage noted on
model plate of tiller.
WARNING: To reduce the risk
of electric shock, use only with an
extension cord intended for out-
door use, such as an extension
cord of cord type SW-A, SOW-A,
STW-A, STOW-A, SJW-A, SJOW-A,
SJTW-A, or SJTOW-A.
6.
Extension Cord - Make sure your exten-
sion cord is in good condition. When us-
ing an extension cord, be sure to use one
heavy enough to carry the current your
product will draw. An undersized exten-
sion cord will cause a drop in line volt-
age resulting in loss of power and over-
heating. The table below shows the cor-
For more information, visit www.desatech.com
®
rect size to use depending on cord length
and nameplate ampere rating. If in doubt,
use the next heavier gage. The smaller
the gage number, the heavier the cord.
To reduce the risk of disconnection of
tiller cord from the extension cord dur-
ing operation use the cord hitch and belt
clip described in this manual.
Total Length of Cord
Volts
in Feet
120
25
50
Ampere
Rating
AWG
10-12
16
16
7.
Ground Fault Circuit Interrupter
(GFCI) protection should be provided
on the circuit(s) for use with this tiller.
Receptacles are available with built-in
GFCI protection and may be used for
additional measure of safety.
8.
Avoid Dangerous Environments. Do
not operate tiller
• while under the influence of alcohol,
medication, or drugs.
• in rain or in damp or wet areas.
• where highly flammable liquids or
gases are present.
• if tiller is damaged, or not fully and
securely assembled.
9.
Always wear eye protection which
meets or exceeds the requirements of
ANSI Z87.1.
10. Always use face or dust mask if oper-
ating tiller in dusty conditions.
11. Always dress properly. Wear the fol-
lowing clothing while using tiller:
• Use of rubber gloves and substantial
footwear is recommended.
• Wear protective hair covering to con-
tain long hair.
• Avoid wearing loose clothing or jew-
elry that could get caught in the ro-
tating tines.
12. Thoroughly inspect area where the tiller
is to be used and remove all foreign
objects.
2
WHILE OPERATING TILLER
1. Stay alert. Use common sense while
operating tiller.
2.
Be aware of extension cord while oper-
ating tiller. Be careful not to trip over cord.
Keep cord away from tines at all times.
3.
Keep all children, animals, and by-
standers away from tiller and extension
cord. Keep the area of operation clear
of all persons and pets.
100
150
4. Grip handlebar firmly with both hands.
Never operate tiller with one hand.
5.
Be aware that tiller may unexpectedly
bounce upward or jump forward if the
14
12
tines should strike extremely hard, packed
soil, frozen ground, or buried obstacles
such as large stones, roots, or stumps.
6.
Do not over reach. Maintain proper
footing and balance at all times.
7.
Do not operate tiller on a slope that is
too steep for safe operation. When on
slopes, slow down and make sure you
have good footing.
8.
IMPORTANT: you can stop the tines
by releasing the trigger lever.
9. Before starting tiller, make sure tines
are not touching foreign objects.
10. Do not allow hands or any body part or
clothing near the rotating tines.
11. Move tiller from one place to another
• with tiller stopped and unplugged.
• by rolling on attached wheel assem-
bly in the down "transport" position.
• by holding carrying handle. Never
use handlebars, tines, tine shaft, or
fender to carry tiller.
12. Do not abuse power cord. Never carry
tiller by power cord or yank it to dis-
connect from receptacle. Keep power
cord from heat, oil, and sharp edges.
13. Do not force tiller. It will do the job
better and with less likelihood of a risk
of injury at the rate for which it was
designed.
109363

Publicidad

Tabla de contenido
loading

Tabla de contenido