Remington GARDEN WIZARD 109312-01 Manual Del Propietário página 5

ASSEMBLY
UNFOLDING AND
ADJUSTING HANDLEBAR
Unfolding Handlebar
1. Loosen handlebar adjustment knobs.
Rotate the handlebar into the operat-
ing position (see Figure 2). Do not force
handlebar. If there is binding, continue
to loosen adjustment knobs. Be careful
not to pinch power cord between
handlebar and lower handlebar support.
2. Tighten handlebar adjustment knobs.
Handlebar
Handlebar
Adjustment
Knob
Lower
Handlebar
Support
Figure 2 - Unfolding Handlebar
109363
Adjusting Height of Handlebar
The handlebar has two possible height set-
tings. The tiller is shipped with the handle-
bar mounted in the standard height or lowest
position. If this height is too short, adjust the
height of the handlebar to the extended
height or highest position.
1. Loosen and remove handlebar adjust-
ment knobs, washers, and saddle bolts
from handlebar.
2. Position handlebar so that the bottom
holes in the handlebar line up with the
holes in the lower handlebar supports
(see Figure 3). Insert the saddle bolts
through the holes and reinstall the
washers and handlebar knobs.
3. Tighten handlebar adjustment knobs.
Standard Height
Saddle
Adjustment Hole
Bolt
Handlebar
Adjustment
Knob
Extended Height
Adjustment Hole
Figure 3 - Adjusting Handlebar Height
5
OWNER'S MANUAL
Folding Handlebar For Storage
1 Loosen handlebar adjustment knobs.
Rotate the handlebar forward and down
over the tiller housing (see Figure 4).
Do not force handlebar. If there is bind-
ing, continue to loosen knobs. Be care-
ful not to pinch power cord between
handlebar and lower handlebar support.
2 Tighten handlebar adjustment knobs.
Handlebar
Adjustment
Knob
Lower
Handlebar
Support
Washer
Figure 4 - Folding Handlebar Down
For more information, visit www.desatech.com
Handlebar
Continued