Publicidad
Idiomas disponibles
Idiomas disponibles
C
IGNITING THE HEATER
NOTE1: When you first use your new heater, ignite it out of the living area of your
house, either in a garage or an outside area protected from strong drafts. Burn it
for about 15 minutes to remove all of the protective oil present on the burner
parts. If this 15 minute "burn-in" is done inside, some objectionable odour will be
observed. This procedure is necessary ONLY THE FIRST TIME you ignite your heater.
NOTE2: If you have fuelled your heater for the first time, or if you are refuelling
it after it has been out of fuel for a long time, you will need to wait about thirty
(30) minutes for the wick to become fully saturated before lighting. Failure to
allow enough time for the wick to become fully saturated may cause permanent
damage to the wick when it is lighted.
Always ignite the heater with the igniter slide. Never use matches or cigarette lighters.
Follow the procedure below:
H
1
NOTE: If you have difficulty igniting the wick, push back the igniter lever very
slightly to remove the igniter coil form direct contact with the wick.
I
After having ignited the heater, always check whether the combustion
chamber ¿ is level, by sliding it slightly to the left and the right by its handle
(fig. I) ´. This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
4
54
Turn the wick adjuster knob clockwise until it stops (Fig. H). This raises the wick to
its maximum height. As the wick rises within the heater, the wick adjuster knob
turns with some resistance and makes a sound like the winding of a clock. Once
the wick has reached its proper height, the automatic extinguisher is fully enga-
ged. Gently push down the igniter lever. The igniter coil should glow and
touch the wick. When flame appears, release the igniter lever. The wick adjus-
ter knob will now move freely left or right to adjust the flame.
Publicidad
