Zibro Kamin Moonlighter Instrucciones De Uso página 61

1 1
2 2 b b
4 4
6 6
8 8
9 9 b b
4
60
REPLACING THE WICK
L
ENSURE THAT THE HEATER IS OFF AND COMPLETELY
COOLED BEFORE STARTING TO REPLACE THE WICK.
Release the automatic extinguisher by pushing down on
1
2 2 a a
the manual shutoff.
Remove the three (3) thumbscrews holding heater
2
cover, and lift cover up. Remove batteries from the
battery holder.
3 Lift the inner heater camber off the hole in the primary
3 3
air tube.
Remove the three (3) wing nuts around the wick
4
adjuster. Lift the wick adjuster off the heater while
moving it slightly back and forth.
Slide two fingers between the orange band on the wick
5
5 5
and the wick adjuster. After lifting all three (3) pins off
the slots, fold the wick and remove it.
Place the wick adjuster on its slide. Next, line up the two
6
(2) openings in the wick adjuster: 1) the diagonal slots
in the fixed part of the wick adjuster, and 2) the slots in
the moving parts of the wick adjuster controlled by the
7 7
wick adjuster knob.
7 Fold the new wick in quarters and insert it into the wick
adjuster from wick adjuster bottom. Place one of the
pins in one of the line-up openings. If you experience
difficulty, gently turn the wick adjuster knob clockwise.
Then insert the two other pins, turning the wick
9 9 a a
adjuster knob if necessary.
8 Finally,
circumference, against the adjuster to insure that it is
firmly in place.
9 Lower the wick adjuster into the fuel tank, guiding the
1 1 0 0 tail of the wick so it fits over the primary air tube and
evenly into place.
Point the wick adjuster knob to the front of the heater.
Insure that the wick adjuster is centered over the studs
on the fuel tank.
gently press the wick, all along its