Replacing The Battery; Cleaning And Care - OWIM HG02408 Instrucciones De Montaje

The product confirms the received signal from the remote control
by a short flashing of the LED spotlight
now set.

Replacing the battery

Improperly changing the battery can cause damage. Remove an empty
battery from the remote control.
Hold the remote control
Press the spring
battery sled
Remove the battery.
Insert a new 3 V
the correct polarity which is shown on the rear side of the remote
control .
8
Slide the battery sled

Cleaning and Care

CAUTION! The product becomes hot when it is switched on.
Allow the product to cool down completely before cleaning.
Before cleaning, remove the fuse or switch off the circuit breaker at
the fuse box.
Never immerse the product in water or other liquids. Otherwise the
product can be damaged.
Clean the product with a lint-free, slightly moist cloth and mild
cleaning agent.
After cleaning, replace the fuse or switch on the circuit breaker.
with the rear panel facing up (see Fig. B).
8
toward the battery compartment
20
out of the battery compartment
21
CR2025 battery into the battery sled
back into the battery compartment
21
. The lighting duration is
2
22
.
22
8
and pull the
. Ensure
21
.
22
GB/IE 33