Door Reversing; Switching On The Refrigerator For The First Time - Proline PLI36G-E-1 Manual De Instrucciones

Door reversing

1. Open appliance door
2. Unscrew door hinge pin
3. Repeate with the lower pin
4. Fit blanking plugs
5. Place appliance door
hole on the door
position. (fig.K)
17
15
c
18
b
Figure K
Figure.K

Switching On the refrigerator for the first time

• Before switching on, install the appliance in an upright position and wait at least three
hours. This will give the refrigerant circuit time to settle and operate efficiently.
• Clean the appliance thoroughly, especially the interior, before use (See Cleaning and
Maintenance).
• Installation of the appliance and electrical connections must be carried out by a qualified
technician, in accordance with the Installation Manual and local regulations.
• Installation procedure into the kitchen unit is given in the Installation section. This product
is intended to be used in proper kitchen units only.
• The appliance must be connected with a properly installed fused socket and connected
to a 220 - 240V 50Hz mains supply.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not fit the socket call a qualified electrician to install
one.
• Manufacturer is not responsible for failure to connect to the ground connection as
described in this booklet.
• There may be an odor when you first switch on the appliance. It will disappear after the
appliance starts to cool.
(14)
.
(16) and screw it to opposite side firmly and take to safe.
(18) . (fig.K.b)
(17) to opposite side. (fig.K.c)
(14)
on the lower pin
(14) and then screw door hinge
a
16
14
UK - 19 -
(18)
and insert top hinge pin
(15) onto opposite side from original
(16)
into hinge