Air Liquide Soffio Cube Instrucciones De Uso página 7

Maximum air pressure at the device
Maximum air flow at the device
Operating air flow with the nebulizer
Nebulizing rate (with NaCl 0,9% solution)
Maximum absorbed power
Dimensions of basic unit
Weight of the basic unit
Noise level at 1 m
Minimum nebulizer filling volume
Maximum nebulizer filling volume
Aerosol output*
Aerosol output rate*
MMAD* (Graph 1)
* measures performed as indicated in UNI EN 13544-1:2009
Graph 1
7 - DISPOSING OF THE DEVICE AND ITS COMPONENTS
At the end of their useful life, the device and its components must be disposed of in
accordance with the current regulations and environmental laws. If no legal obligations exist,
the various materials must be sorted and disposed of separately. The table below shows the
materials of which the various components are made.
None of the materials used contains phthalates or traces of natural latex.
SH • ENGLISH • ENGLISH • ENGLISH • ENGLISH • ENGLISH
1,85 bar
10 l/min
5 l/min
0,35 ml/min
150 VA
135x140x155H mm
1,1 kg approx
58 dBA
2ml
12 ml
0,1436 ml
0,87 ml
2,61 μm
The y-axis of the graphs represents
the percentage of volume of
atomised solution with sizes lower
than the corresponding dimensional
value expressed in μm on the x-axis.
50% by volume of the atomised
particles is less than the MMAD
(Median Mass
Diameter). This value is indicative
of the Nebuliser's ability to produce
particles suitable for a specific
therapeutic treatment.
The shown MMAD value has been
measured with a cascade impactor
ACI Marple 290.
Aerodynamic