Virax VISIOVAL 294020 Manual De Instrucciones página 15

When the camera is running and the batteries are completely charged the start-up
button is green.
The battery charge indicator is in the top right of the screen.
The batteries must be recharged when the indicator shows a low charge level:
1 - Connect the system's power supply unit to the slot provided on the
2 - Connect the power unit to the mains.
When placed to charge, only the battery in the top corner will be charged. You must
swap the batteries round to charge the 2
An external quick charger is available as an accessory (ref. 294032) to charge each
battery separately (charge time: +/- 1h30)
b) Setting the date and time (294030/294040)
c) Use
Once the Visioval has been switched on, simply pull the cable and push it into the
pipe or place to be inspected.
- Pull and push the cable in a regular and even manner; do not force the
cable if it becomes jammed. Do not rub the cable on sharp edges. Do not
fold or twist the cable.
- Always remember to protect the content of the case from water.
Before you roll the cable up inside the case, ALWAYS wipe the flexible cable with a
soft, damp cloth (no solvents). If the lens is dirty, wipe it with a soft, damp cloth (no
solvents).
While the batteries are loading (3h max), the button
flashes red.
After the batteries are charged the button glows
steady red.
nd
one.
1 – With the camera off, press the ▲ key and hold it
down while switching the camera on.
2 – A menu appears on the screen: Date / time /
measurement unit (metres or feet) / date indication
format
DD.MM.YY or DD/MM/YY) / 12 or 24-hour clock.
3 – The arrow keys are used to browse the menus
and the values can be modified using the up and
down keys.
4 – Press the ON / OFF button to exit the menu
Page
15
-EN-