Tabla De Contenido; Safety Instructions; Assembly - Texas HMH 5500S Manual De Instrucciones

UK - Table of contents
Safety instructions ........................................................... 4
Assembly ......................................................................... 4
Clothing ........................................................................... 5
Use .................................................................................. 5
Adjusting the depth skid .................................................. 5
Adjusting the support wheels .......................................... 5
Cleaning the tiller ............................................................ 5
Maintaining the gear box ................................................. 5
Engine ............................................................................. 5
Storage............................................................................ 5
Troubleshooting: ............................................................. 6
Specifications .................................................................. 6
Spare parts
Spare part drawings for the specific product can be found
on our website www.texas.dk
If you find the part numbers yourself, this will facilitate
more rapid service.
For purchase of spare parts, please contact your dealer.
You will find a list of dealers on the Texas website.
We would like to wish you good luck with your new tiller.
We are convinced that this machine will fully meet your
expectations. In order to get the maximum from your
machine, you should read through these operating
instructions carefully. This will avoid unnecessary
problems. You should pay particular attention to the
safety instructions, which are marked with this symbol:

Safety instructions

When operating the tiller, follow these safety instructions
carefully. Read all of the operating instructions before
starting the machine. Make sure you are capable of
stopping the machine immediately and switching off the
engine in the event of an emergency. All instructions for
the handling and maintenance of your tiller are also for
your own safety!
The tiller must not be used in any other way
than described in the manual.
Use only genuine equipment and spare
parts. If you use non-approved spare parts,
there is increased risk and this is, therefore,
not permissible. All liability is renounced in
the event of an accident or other damage
caused by the use of non-approved parts.
Before using the machine for the first time,
the dealer or other knowledgeable person
must instruct in its use.
When using the tiller you are responsible
for any third party in the area where the
machine is in operation. Never use the tiller
in the presence of others, especially
children or animals.
Do not allow minors to operate the tiller.
The tiller may only be lent to persons who
are familiar with operating the machine.
Always pass on the safety and operational
instructions.
Only allow persons who are rested, healthy
and fit to operate the machine. If the work
is tiring, take a break in plenty of time. Do
not operate the machine after drinking
alcohol.
Do not remove or cover the controls which
are mounted on the tiller at the factory, e.g.
removing the clutch lever from the
handlebar.
Remember to tighten all bolts and nuts
before starting.
When the engine is running, do not pull the
handle for forward speed and the handle for
rear speed at the same time! This will
damage the transmission. Always release
one handle before the other is used.
"Beware of the rotating knives"
Working with the machine on a steep slope is
Only use the machine on areas where it can be

Assembly

1. Figure 1 shows the contents of the package:
a. Tiller with upper steer and cables.
b. Blades
c. Lower steer
d. Side guards
e. User manual and bolts
2. Mount lower steer using the accompanying bolts
and nuts.
Figure 2.
3. Mount upper steer using the accompanying
bolts and handwheels.
Figure 3.
4. Mount the side guards using the accompanying
bolts and nuts.
Figure 4.
5. Mount the blades using the cotter bolts and
pins.
It is important that the edge of the blade turns
forward, as shown in figure 6, a.
Figures 5, 6.
WARNING: Follow the user manual guide to fill the
engine with oil and fuel.
4
dangerous!
handled safely.