Ego Power+ SNT2100 Manual De Funcionamiento página 29

2. Use needle nose pliers (not included)
to remove the spring from the
hook to release the belt tension
(Fig. 30 & 31).
3. Remove the drive belt by
slowly turning the auger pulley
counterclockwise while pulling the
belt outwards (Fig. 32).
4. Install the new drive belt, rotating it
onto the pulleys (Fig. 33).
Tips: Rotate the new drive belt first
around the engine pulley, then the idle
pulley, and finally around the auger pulley.
Slowly turn the auger pulley clockwise to
drive the belt inwards (Fig. 29).
5. Use needle nose pliers to install the
spring onto the hook to tension the
drive belt (Fig. 30).
6. Reinstall the drive belt cover with the
8 Torx screws removed in step 1
(Fig. 28).
32
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100
Spring
29
Drive Belt
Auger Pulley
30
31
33
Hook
Engine
Pulley
Idler Pulley
Needle nose pliers
29