Safety Regulations; Layout; Intended Use; Technical Data - EINHELL BG-CS 235 E Manual De Instrucciones

Anleitung_BG_CS_235_E_SPK7:_
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Chain stopper
2. Chain stopper setting screw
3. Scale for setting grinding angle
4. Locking screw for grinding angle setting
5. Chain bar for chain
6. Chain locking screw
7. Setting screw for limiting depth
8. Grinding wheel
9. ON/OFF switch
10. Grinding head
11. Base frame
12. Roof cutting angle scale
13. Handle

3. Intended use

The chain sharpener is designed for sharpening saw
chains.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
10
29.07.2008 9:53 Uhr Seite 10
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Rated voltage:
Power input:
Idle speed:
Adjustment angle:
Grinding wheel Ø (inside):
Grinding wheel Ø (outside):
Grinding wheel thickness:
Lpa noise level:
Lwa peak noise level:
Protection class:
Weight:

5. Before starting the equipment

The entire assembly process may only be carried out
after the power plug has been pulled.
Fitting the grinding head (Fig. 3a/3b)
The equipment consists of the grinding head (10)
and the base frame (11) which must still be fitted.
Insert the centering pin of the grinding head into the
opening of the base frame. Now insert the hexagon
head bolt (A) from the front through the hole in the
grinding head and the oval hole in the base frame
and secure on the back with a washer (B) and a star
screw (C).
Fitting the handle (Fig. 4)
Screw the handle (13) into the intended hole on the
grinding head (10).
Mounting on a table or wall (Fig. 5/6)
The equipment is designed for both table top
installation and wall mounting.
When installing the equipment on a table top, first
make sure that the edge of the equipment is flush
with the edge of the table, then secure the
equipment with the holes (A).
When mounting the equipment on the wall, use the
holes (C) to secure the equipment. Spacer sleeves
230V 50Hz
~
235 watts
-1
3000min
40º to the left and right
22 mm
max. 145 mm
3.2 mm
71,3 dB (A)
84,3 dB (A)
I
5.8 kg