Important - BABYTREND Sit N’ Stand Snap Fit Manual De Instrucciones

ASSEMBLY

IMPORTANT!

To ensure safe operation of your stroller, please
follow these instructions carefully. Please keep these instructions for future
reference.
IMPORTANT!
Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. NEVER use if
any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
Remove stroller from box. The front and
rear wheels MUST be installed prior
to use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the following section:
1) • Unlock the release lever (Fig. 1a) and
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 1b).
• Lean the stroller backwards and push
each front wheel assembly into the front
wheel housing until they lock into place
(Fig. 1c).
NOTE: Pull on the wheel assembly
to ensure that it is securely attached
to the stroller.
5
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
REAR WHEELS
2)
BUMPER BAR
3)
Fig. 1a
Fig. 1b
Fig. 1c
• Position rear axle over the rear leg
tubes, brake pedals facing the back.
At the same time, push down applying
equal pressure to both sides until they
lock into place (Fig. 2).
NOTE: Pull on the rear wheels to ensure
that it is securely attached to the stroller.
WARNING:
Do not use
bumper bar to carry seat with
child inside. The bumper bar is
not a carrying handle.
• Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it locks into place (Fig. 3a).
Note: The bumper bar must be securely
attached before using this product.
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
upwards to access the seat (Fig. 3b).
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 2
Fig. 3a
Fig. 3b
6