Installation And Connections; Programming - Fermax EXTRA-500 Manual De Usuario

Cod. 97844 V06_17

INSTALLATION AND CONNECTIONS

Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the
cables through the bottom of the receiver. Connect the power cables to the terminals marked
in the mother board, as indicated. Fix the receiver front to the rear part using the screws
supplied.
OPERATION
The lights on the screen blink to indicate correct power supply to the equipment.
On receiving a code the equipment checks if it is in the memory, activating the programmes
relay(s).
If the equipment code is not stored in the memory, the equipment will not perform any action,
and the message "no" will be displayed on the screen.
MENUS
To access the menu, press any key and enter the password using the   keys.  increases
number,  changes digit, C confirms password. If the password is incorrect, the message "Err"
is displayed on screen and the equipment emits a bleep.
The manufacturer set password is written on a sticker located on the memory card.
The menus that will be displayed are: Mod1 (basic mode), Mod2 (advanced mode), ---- (exit).
  are used to change mode. To confirm each option, press the C key.

Menu scrolling key

Menu scrolling key
C Menu accessing or option validating key
If no action is performed, the equipment exits the program automatically after a period of 60
seconds and emits two short beeps.
Screen
display
Mod1
Mod2
BASIC MODE (Mode1):
Allows programming in multi-channel mode and individual cancellations.

PROGRAMMING:

The screen displays 001, which indicates the first memory position.   increase or decrease
the memory position. Place in the desired position and press the channel of the transmitter to
be programmed. If   are kept pressed down for more than 3 seconds, the positions
increase or decrease rapidly. If a memory position is taken, this will be indicated by a dot on
the screen.
Description
Basic mode: Allows programming in multi-channel mode and individual
cancellations.
Advanced mode: Allows complete management of the unit:
programming (F.1), cancellations (F.2), time configuration (F.3) and
relay configuration(F.4).
8
1247085/1.0