Service And Maintenance; Trouble Shootings - Nitto Kohki delvo DLV02SL-CKE Instrucciones De Uso

5.SERVICE AND MAINTENANCE

1. Have the screwdriver or components repaired by a qualified or trained person only.
2. For the purpose of making proper use, request the following check and maintenance by an authorized
service facility.
DLV02 / DLV12 / DLV16
Routine inspections and
Parts to be replaced
Routine inspection
(1) Operation check
(2) Grease-up
Routine inspection and parts to be replaced
(1) Motor assembly
(2) Power cord
(3) Spindle gear head assembly
(4) Gear case assembly
(5) Cam rollers and Cam guide balls
(6) Cam guide
(7) Spindle bearing
Contents for operation check
Operation check items
(1) Does screwdriver rotate for both
directions smoothly?
(2) Does screwdriver stop at one index of
the clutch?
(3) Is the torque decreasing?
3. In case of trouble or repair of this product, contact an authorized service facility
4. Electric tools, accessories, and packaging should be disposed of for recycling in an environmentally friendly
manner. Do not dispose of electric tools into household waste!
If your tool can no longer be used, deliver it to a sales representative.

Trouble shootings

Problem
(1) No Rotation.
(2) Output torque is low.
(3) The screwdriver is
overheating abnormally.
The Repair Parts List is reference attached sheet.
If the abnormality still does not disappear, contact your sales representative from which you purchased the tools.
WARNING
Please have the product inspected periodically at the store of purchase or a Nitto Kohki-approved service
center. Failure to perform periodic inspections may result in short circuiting.
Number of Tightening (million)
0.5
○
Check procedure
With tool plugged, turn on the reverse switch to forward or reverse
position and turn on the switch.
Then check if the tool rotates smoothly.
Check if the motor stops instantly at the moment a screw was
tightened up.
Check by torque checker or equivalent.
Check item
Is the power plug of the power cord connected
to the power source outlet?
Is the changeover switch set to "
Is the output torque correctly set?
How much time is "OFF" time?
Is the input voltage correct?
Is not the maximum scale value exceeded?
1.0 1.5
○ ○
Connect the power plug of the power cord to
the power source outlet securely.
or " ? Set the changeover switch at "
Check it by Torque Checker.
Lengthen "OFF" time more than "ON" time.
Check the Rating label of the main body.
Check the input voltage.
Set the torque below the maximum scale.
8
2.0
○
○
○
○
○
○
○
○
○
Countermeasures
or ".