Sewing On Buttons (Model 3232) - Singer 3221 Manual De Instrucciones

Sewing on Buttons (Model 3232)

EN
Install the darning plate. (1) Change the all purpose foot to
the button sewing foot. (2) Set the stitch length to "0".
To sew a few securing stitches, set the machine for straight
stitch, with the stitch width set at "0".
Raise the needle out of the fabric. Set the machine for zig-
zag stitch, then set the width to number "3" - "5". Turn the
handwheel to check that the needle goes cleanly into the left
and right holes of the button. Adjust the stitch width, as
needed, according to the distance between the holes of the
button. Slowly sew on the button with about 10 stitches.
Raise the needle out of the fabric. Set the machine for
straight stitch again, with the width at "0" sew a few securing
stitches to finish.
1 2
If a shank is required, place a darning needle on top of the
button and sew. (4)
For buttons with 4 holes, sew through the front two holes first,
push the work forward and then sew through the back two
holes.
4
3
39