Maintenance And Cleaning - Einhell Royal AGS 7,2 Manual De Instrucciones

Anleitung AGS 7,2 11.02.2005
fully discharged.
The blades must be kept in the black guard hood
when the grass cutter is not in use.
7.3 Fitting the long handle
Using the plug-in long handle (Figure 1 / Item 5) you
can push the cordless grass cutter on wheels over
the lawn.
Slide the one tube into the other until they latch
together at the locking point (Figure 3). Press down
the release lever on the handlebar (Figure 4 / Item
1) and plug in the long handle. The long handle will
engage in place automatically when you let go of the
release lever. Connect the power supply of the long
handle to the tool (Figure 5). To remove the long
handle, press down the release lever (Figure 4 / Item
1), pull out the long handle and disconnect the power
supply.
Important!
The switching arrangements installed on the tool
by the manufacturer must not be removed or
bypassed, e.g. by fitting a switching button to the
handle, as this may result in risk of injury and the
tool will no longer switch off automatically.

8. Maintenance and cleaning

To achieve good results you should keep the blades
sharp at all times. In particular we recommend that
you immediately level off any jags or ridges caused
by stones or the like. The tool should be thoroughly
cleaned both before and after use. A few drops of oil
(e.g. sewing machine oil) will improve the cutting
performance of the blades, but never apply any
grease to the blades. To ensure constant exact
cutting it is also important to remove grass remnants
and dirt from between the upper and lower blade.
Important!
Never clean the tool under running water - and
particularly never with high pressure - because
of the potential danger to persons and property.
Keep your cordless grass cutter and hedge
trimmer in a dry and frost-proof place. Choose a
place that children are unable to enter.
9. Troubleshooting
The tool does not cut cleanly:
Check the blades and replace them if necessary.
In case of any other faults, please contact the ISC
Customer Service Center.
6:57 Uhr Seite 9
We draw express attention to the fact that we are
not responsible within the meaning of the
Product Liability Law for any damage caused by
our products if said damage results from
incorrect repair or the use of replacement parts
which are not original Einhell parts or parts
approved by us and the repair is not carried out
by the ISC Customer Service Centre.
GB
9