Plumb - Pacific Laser Systems PLS3 Manual De Instrucciones

To establish plumb with the PLS 5 and PLS 3 , place the #2 down beam over the mark to be
transposed. See Fig.1. The #3 up beam is exactly plumb within specification. You can
shoot plumb marks down and up, or cantilevered over the edge of a building/shaft opening
or floor track, etc. See Fig.2. Use the floor stand with your PLS 5 or PLS 3 to increase the
sight angle of the #2 down beam.
The PLS 3 and PLS 5 can quickly survey existing conditions for plumb. Use a tape
and #3 up beam. Position the laser near the structure.
Check any distance up or down the structure. It is also
possible to transpose marks from a roof or ceiling down to
the floor. Move the laser until the #3 up beam hits the edge or
center of the ceiling component to be transposed. Mark the
floor at the #2 down beam. See Fig. 2 and 3.
FIG. 2

Plumb

FIG. 3
PLUMB
POINT
FLOOR
LAYOUT
#3
FIG. 1
#2
CENTER BEAM
ON LAYOUT
6