Technical Data - LaserLiner SensoPilot Pro Manual De Instrucciones

Operation of remote display
Power supply
• In the case of battery operation, power is supplied from the SensoPilot.
• For operation from the battery of the construction machine, connect the remote display (13) using
the 12/24V battery cable, ensuring that RED is connected to the positive battery pole (+) and BLACK
to earth (engine block). The SensoPilot is then also supplied with power via the connection cable -
see illustration below.
Use of the remote display
The remote display allows laser reception of the SensoPilot to be monitored when this cannot be seen
from the cab of the construction machine. In this case, connect the remote display (12) to the SensoPilot
(4) using the connection cable and install the remote display in the operator's cab.

Technical data

Laser reception range
Precision HIGH
Precision LOW
Battery / Charger
Battery operating time / Charging time
Working temperature
Dimensions
Weight of SensoPilot / remote display
EU directives and disposal
This device complies with all necessary standards for the free movement of goods
within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: http://laserliner.com/info?an=sesopipr
10
EN
4 12
Connection cable from
SensoPilot to remote display
13
12/24 V battery cable
200 m
± 2 mm – ± 5 mm
± 5 mm – ± 15 mm
7,2 V NiMh / 2500 mA
approx. 40 hours / approx. 15 hours
-20°C ... 50°C
390 x 170 x 85 mm
3,4 kg / 1,1 kg
Technical revisions reserved. 18W16