LaserLiner MultiMeter-Home Manual De Instrucciones página 15

2
Notes on measurement
Before each measurement, check that the pointer is set exactly
to „0" on the
with rotary knob (2).
If the value of the measured variable is not known in advance,
set the rotary switch to the highest measuring range.
Then reduce the measuring range step by step until a satisfactory
resolution is achieved.
If the pointer remains to the
left of the 0" during the
"
measurement or to the right
of the 0" when measuring
"
resistance, either the test prods
are mixed up or the measuring
circuit is interrupted. Repeat
the measurement with the test
prods changed over.
3
Voltage measurement DC
To measure voltage, set the rotary
switch to the "
the corresponding measuring range
(12 V - 300 V).
Then connect the measuring contacts
to the object to be tested.
Reading the scale (B):
Measuring
Scale
range
12 V 0 - 12
60 V 0 - 60
120 V 0 - 12
300 V 0 - 300
/ -scale (B/C). If not, adjust the pointer
" position with
Result
x 1
x 1
x 10
x 1
MultiMeter-Home
The measuring range is exceeded
if the pointer remains to the
right of 300" (
"
or to the left of
measuring resistance. Repeat
the measurement with a higher
measuring range.
200
black
60" / 12")
" "
1 kΩ" when
"
red
15
EN