Installation (continued)
INSTALLING THE STRAINER
- Apply plumbing putty or silicone sealant to the top side of the
drain opening .
- Insert the strainer body into the drain opening and press it down
until it is evenly seated .
- Assemble the rubber gasket, friction washer and strainer locknut
onto the strainer body from underneath the sink . Hand tighten
the strainer locknut until it is snug .
Do not overtighten .
- Insert the plastic flange into the flange-end of the tailpipe (not
supplied) then secure the tailpipe to the strainer body using the
connecting nut . Tighten the connecting nut until it is snug . Do
not overtighten .
- Remove excess sealant from around the drain opening .
NOTE:
The tail pipe is not supplied.
QL035
Sink
8
Strainer Basket
Strainer Body
Sealant
Rubber Gasket
Fiber Washer
Strainer Locknut
Plastic Flange
Tailpipe
Connecting Nut