Maintenance And Cleaning - Berner BAG 115-2 Manual De Instrucciones

OBJ_BUCH-2484-002.book Page 20 Tuesday, June 9, 2015 11:18 AM
Action
Grey-marked area: Han-
dle (insulated gripping
surface)
Selecting the admissible
grinding tool

Maintenance and Cleaning

 For safe and proper working, always keep the
machine and ventilation slots clean.
In extreme conditions, always use dust extrac-
tion as far as possible. Blow out ventilation slots
frequently and install a portable residual current
device (PRCD). When working metals, conductive
dust can settle in the interior of the power tool. The
total insulation of the power tool can be impaired.
Please store and handle the accessory(-ies) care-
fully.
If the replacement of the supply cord is necessary,
this has to be done by Berner or an authorized
Berner service agent in order to avoid a safety haz-
ard.
In all correspondence and spare parts orders,
please always include the article number given on
the type plate of the machine.
20 | English
Figure Please observe
14
15
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
According to the European Directive
2012/19/EU for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must
be collected separately and disposed
of in an environmentally correct man-
ner.
Subject to change without notice.
Page
236
237
1 609 92A 101 • 9.6.15