Operation; Preparing For Use - Hilti TE 1000-AVR Manual De Instrucciones

10. To remove the side handle, follow the assembly
instructions but carry out the necessary steps in the
reverse order.
NOTE When fitting and positioning the side handle,
pay attention to the description enclosed with the
side handle.
en
6.2 Connecting the supply cord to the power
tool 3
CAUTION
The releasable electric connector may be connected
to the power tool only when it is clean and dry and
when under no voltage (i.e. disconnected from the
electric supply). Disconnect the supply cord plug from

7 Operation

DANGER
Always hold the power tool securely with both hands
on the grips provided. Keep the grips dry, clean and
free from oil and grease.

7.1 Preparing for use

CAUTION
Wear protective gloves when changing insert tools
as the insert tools get hot through use and they may
have sharp edges.
7.1.1 Fitting the insert tool 4
NOTE
The chisel can be adjusted to 6 different positions (in 60°
increments). This ensures that flat chisels and shaped
chisels can always be set to the optimum working posi-
tion.
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
3. Check that the sealing lip of the dust shield is clean
and in good condition. Clean the dust shield if nec-
essary or replace it if the sealing lip is found to
be damaged (please refer to the "Care and mainte-
nance" section).
4. Push the insert tool into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
5. Push the insert tool further into the chuck until it is
heard to engage.
6. Check that the insert tool has engaged correctly by
pulling it.
8
the electric power outlet before disconnecting the
releasable supply cord connector from the power
tool or before cleaning it.
1. Remove the supply cord from the cardboard box.
2. Push the keyed releasable electric connector into
the socket on the power tool as far as it will go.
3. While pushing it in under light pressure, turn the
keyed releasable electric connector in a clockwise
direction until it is heard to engage.
4. Plug the supply cord into the power outlet.
6.3 Use of extension cords and generators or
transformers
See section "Description / use of extension cords".
7.1.2 Removing the chisel 5
DANGER
Do not lay a hot insert tool down on flammable mate-
rials. This could cause the material to ignite, resulting in
a fire.
1. Disconnect the supply cord plug from the power
outlet.
2. Open the chuck by pulling back the locking sleeve.
3. Pull the chisel out of the chuck.
7.2 Operation
WARNING
If the power tool starts without pressing the on/off
switch when the supply cord is plugged back in after
unplugging, the power tool must be brought to Hilti
Service immediately.
WARNING
Unplug the supply cord if the on/off switch is found
to be faulty.
CAUTION
Working on the material may cause it to splinter. Wear
eye protection and protective gloves. Wear breathing
protection if no dust removal system is used. Splin-
tering material presents a risk of injury to the eyes and
body.
CAUTION
The work generates noise. Wear ear protectors. Expo-
sure to noise can cause hearing loss.