Toto Kiwami Renesse TS170A Manual De Instrucciones página 6

CAUTION
Showerhead requires Kiwami® Renesse® Volume
Control Valve and Kiwami® Renesse® Thermostatic
Mixing Valve.
1. Before installation, the water pipes must be
completely flushed of dirt and debris.
2. Create hole for the showerhead supply pipe that
does not exceed 1" (25mm).
CAUTION
If the hole is larger than 1" (25mm) the installation
will fail.
3. Apply pipe sealing tape to
the pipe adapter.
4. Screw the adapter into the
water supply pipe firmly.
5. According to your set up
option, connect the valves to
the water supply lines. Check
for leakage.
6. Confirm the gap between
the finished wall and the
pipe adapter carefully.
InSTAllATIon PRoCeDURe
O-rings
6
Pipe tape
RECOMMENDED
GAP: 3/16"(5 mm)
Allowable range:
0-3/8"(0 to 10 mm)