Laser Output - LaserLiner ThermoSpot Plus Manual De Instrucciones

a f
b
g
c
d
e
4
Continuous measurement / Hold
For continuous measurement
activate the laser (see figure)
and keep the button pressed.
Laser circle
The laser circle is a targeting aid to sight the location for the infrared
measurement. Temperature measurement is only performed on the
surface within the laser circle. Please ensure that the space between
the instrument and surface to be measured is free of disturbances
(steam, gas, contamination, glass).
5
MAX display
The MAX display determines the maximum measured
value within the context of a continuous measurement
(keep trigger button pressed). As soon as you release the
trigger button and press it again to start a new measure-
ment, the MAX value will be reset and the instrument will
start the process of recording the maximum measured
value all over again.
h
i
Laserstrahlung!
Nicht in den Strahl blicken.
Laser Klasse 2
< 1 mW · 650 nm
EN 60825-1:2007-10
ThermoSpot Plus
Rev.1114
ThermoSpot Plus
a Laser beam switched on
b Battery charge
c Hold function
d Measured value display
e Max. value during the
measurement / Emission
coefficient
f Display lighting
g Unit of measurement °C
h Set emission coefficient
i ON / Measure
Release the button as
soon as the laser circle
pinpoints the measure-
ment location. The
measured value is held.

Laser output

Laserstrahlung!
Nicht in den Strahl blicken.
Laser Klasse 2
< 1 mW · 650 nm
EN 60825-1:2007-10
ThermoSpot Plus
Rev.1114
Laserstrahlung!
Nicht in den Strahl blicken.
Laser Klasse 2
< 1 mW · 650 nm
EN 60825-1:2007-10
ThermoSpot Plus
Rev.1114
Laserstrahlung!
Nicht in den Strahl blicken.
Laser Klasse 2
< 1 mW · 650 nm
EN 60825-1:2007-10
ThermoSpot Plus
Rev.1114
Laserstrahlung!
Nicht in den Strahl blicken.
Laser Klasse 2
< 1 mW · 650 nm
EN 60825-1:2007-10
ThermoSpot Plus
Rev.1114
Laser warning message
1x
GB
07