Current Time - LaserLiner ClimaData Box Manual De Instrucciones

5.3
Options when starting to measure
Measurement can be started manually, automatically or after the set time.
Manually
Automatically:
Time lag on start:
5.4

Current time

"Current time" displays the set date and time. You can change the date
format in this menu.
5.5
Alarm function settings
Alarm setup
Temp alarm low Temp alarm high
RH alarm low RH alarm high
DP alarm low DP alarm high
LED flashes when alarm signals low / high
Alarm when recording is not active
18
EN
Hold the key (1) down to start or stop measurement.
Measurement starts as soon as the device is
disconnected from the computer.
Measurement commences at the end of the set time.
The alarm range can be freely defined for
the three measurement variables: Tempera-
Unit
ture, relative humidity and dew point. If the
Celsius
measuredvalue goes above or below the set
cap or floor, the alarm LED (2) flashes once
a minute.
LED red: Max./min. temperature exceeded
LED yellow: Max./min. humidity exceeded
LED flashes when alarm signals low / high:
The alarm function can be switched on or
off.
Alarm when recording is not active: A signal
is issued when the recording function (REC)
is not active.