LaserLiner ClimaData Box Manual De Instrucciones página 19

5.6
Continuous / Non-continuous recording
Continuous recording:
Non-continuous
recording:
6
Notes on the measurement process and on use
1. Connect ClimaData Box to the PC
2. Download and backup any existing data. Starting or configuring
a new measurement deletes all existing data.
3. Configure the recording function in the Setup menu and save your settings
4. Depending on your start parameter, position the device at the measuring
point and record measurements. If set to manual start, hold key 1 down.
The display shows "Rec" to indicate that measurement recording is active.
5. To stop recording, either hold key 1 down again, or recording stops when
the memory is full, depending on the set parameter.
6. Connect ClimaData Box to the PC, download and backup data.
!
Position the device upright to ensure sufficient air circulation around
the sensor. Use the supplied wall bracket.
If the device has been placed in a cold and/or very humid environment,
!
condensation may form in the sensor housing when it is removed due
to the change in climate. Position the device upright for a while to
allow it to acclimatise.
7
Download
To edit and document the recorded data, they must be transferred to the
software program. To do this, start the software and connect the device
to the PC vis USB interface.
Connected
Download
The device records until manually stopped.
Older measurements are overwritten.
Recording stops automatically when the data
memory is full.
Cancel
ClimaData Box
EN
19