Publicidad
Idiomas disponibles
Idiomas disponibles
DIMMER 2CH - REV003A
The dimmer pack can be used in three different manners:
• Stand-alone operation: the dimmer controls 2 light channels independently through two inputs.
• Programmable bus mini-system operation: up to 32 dimmers can be connected by serial line, allowing full customiza-
tion of the light sources. All the settings are done by Quick.
• Slave operation: the unit can interface with other on-board systems, such as monitoring systems and audio/video
entertainment systems. All the settings are done by Quick.
Bus communication is monitored by the flashing of the "BUS" LED, as follows:
• 0.5 sec on and 0.5 sec off: bus not connected or improperly connected.
• 2 sec on and 0.25 sec off: bus properly connected and working.
LDIM-BUS-2CH CONNECTIONS
ALIM. OUTPUT 1 OUTPUT 2
ON
DIP
1 2 3 4
PUSH
Operating
BUTTONS
INPUT
DO NOT UNDER ANY CIRCUMSTANCES CONNECT THE LEDS DIRECTLY TO THE TERMINALS OF THE
POWER SUPPLY. THE LEDS CAN BE CONNECTED ONLY TO THEIR RESPECTIVE TERMINALS, OTHERWISE
THE OUTPUTS REMAIN UNPROTECTED AND THE UNIT IS EXPOSED TO DAMAGE.
QUICK SPA
Wiring, terminals and cables
Considering the high currents involved, a few precautions on wiring
are in order:
• the cables used for the power stage should be no longer than 20 m.
• Use cables having an adequate cross-section (max. terminal size 2.5
• For connections to the serial line use cables with max. cross-section
EasyBus
mm
), both for connecting the power supply and wiring the devices.
2
1 mm
.
2
9
OPERATION
EN
Publicidad
