Carat Dustcatch Pro Manual De Instrucciones página 13

GRINDING
1. Turn on the Vacuum.
2. Securely hold the Handle of the grinder.
3. Turn on the angle grinder.
4. Place the [a] Main Body on the material and slowly
move over the surface to be ground.
Fig.16
CORNER GRINDING
1. Make sure that the angle grinder
and Vacuum are turned off.
2. Lift the angle grinder away from the material.
3. Open the Front Lid by pulling the Slider.
(Fig.17)
[CAUTION]
The wheel dia. must be max.180mm to
prevent the over grinding. (Fig.18)
max.180mm
(90mm)
Fig.18
Hoofdkantoor in Nederland
Carat Nederland B.V.
Nikkelstraat 18, 4823 AB Breda
(Fig.15)
N G
4. Turn on the Vacuum.
5. Turn on the angle grinder while ensuring the handle is gripped firmly .
6. Place [a] Main Body on the material and slowly move toward the grinding
direction along the wall.
7. Turn off the angle grinder and vacuum, then close the Front Lid. (Fig.20)
Fig.19
Vacuum
Fig.15
[CAUTION]
Don't grind over the edge of the material as some
dust could escape. (Fig.16)
Slider
Fig.17
(Fig.19)
Vacuum
Fig.20
22-5-2019
Kees van Beek
Managing Director
Front
Lid
-13-