Description Of Controls; Using The Dispenser; Configuration Mode - Bras B-express Manual De Instrucciones

EN GLIS H
B - E X P R E S S

5. 2 DESCRIPTION OF CONTROLS).

6 Lower the front cover, the dispensing nozzles and the drip
tray following the procedure above in reverse order (see figure
1).
IMPORTANT
The dispenser must always be used with the covers of
the water tank and powder containers assembled, and
with the front cover and drip tray correctly installed, in
order to avoid contamination of the foodstuffs with
external agents.
5. 2 DESCRIPTION OF CONTROLS
There is a master switch on the upper half of the dispenser at
the front. This switch is used to switch the dispenser on and off.
The dispenser also has a capacitive keypad (see figure 6) the
functions of which are illustrated below :
(1) Standby button : press it for 2 seconds to switch from Standby
mode to Ready mode and vice versa.
In configuration mode, press this key to confirm
the current selection and go to the next menu.
CONFIRM key (OK).
(2) Button to dispense : press to dispense the complete dose of the drink
complete dose of on the left hand side.
Left drink
In configuration mode, press this key to scroll up.
UP key ().
(3) Button to dispense : press to dispense half the dose of the drink on the
half dose of Left left hand side.
drink In configuration mode, press this key to scroll
down. DOWN key ().
(4) Button to dispense : press and hold to dispense only hot water from the
water from Left unit left hand unit.
In configuration mode, press this key to cancel the
selected option and return to the menu option
above. CANCEL key (C).
(5) Button to dispense : press to dispense the complete dose of the drink
complete dose of on the right hand side.
Right drink
(6) Button to dispense : press to dispense half the dose of the drink on the
half dose of Right right hand side.
drink
(7) Button to dispense : press and hold to dispense only hot water from the
water from Right right hand unit.
unit
(8) Display : if present, it shows in full all the alarm messages
managed by the dispenser.
(10) Smart Card reader : (see paragraph 5. 5 SMART CARD (OPTIONAL))
(optional)
figure 6

5. 3 USING THE DISPENSER

1 Prepare the dispenser as described above (see paragraph
5. 1 DISPENSER SET UP).
2 Turn on the dispenser at the master switch. The display
shows the current software version and, at the end of the
starting cycle, the dispenser goes into standby and the OFF
message appears on the display:
COMPANY logo
In this mode, the dispenser is inactive, the water is not heated
and no dispensing can be carried out.
The only functions available when the dispenser is in standby
are loading of credit from a Smart Card (see paragraph 5. 4
CONFIGURATION MODE) and access to the Configuration
Menu (see paragraph 5. 5 SMART CARD (OPTIONAL)).
3 Press the Standby button (1) briefly and the dispenser
starts the "Ready for dispensing" phase. The heating phase
begins, during which time these icons appear in order on the
display:
During this phase, all dispensing operations are disabled
except for the dispensing of only water.
4 At the end of the heating phase, the dispenser prepares
itself to receive commands and the following information is
shown on the display:
5 The dispenser is now ready to dispense the desired drinks.
6 Pressing any key during dispensing stops it instantly.
7 After dispensing, you may need to wait a few seconds for
the water temperature to return to the set level before it is
possible to dispense another drink.

5. 4 CONFIGURATION MODE

When the dispenser is in Standby mode, press the key (2) to
access the Configuration Menu of the dispenser. The structure
of the menu:
SET LANGUAGE
ITALIANO
ENGLISH
FRANCAIS
12