Nordcap CR 90 Serie Manual De Instrucciones página 6

FUNCTION
Storing food
To get the best results from your appliance, follow these instructions:
• Only store foodstuffs in the appliance when it has reached the correct operating temperature.
• Ensure GN container bays are full at all times, even if the GN containers are unused or empty. Empty bays will greatly reduce
efficiency of the appliance.
• Always close the door,lid or drawer when not in use.
• Do not place uncovered hot food or liquid inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors/drawers for prolonged periods of time.
• The maximum load for a shelf/drawer is 30 kg.
• The food must be put into container before placed into cabinet or on the shelf. Food must not be placed into food cabinet directly.
• When wet food/vegetable is put in the Saladette, it's normal that ice (snow) appears on the surface.
Turn on
• Close the door/lid/drawer of the appliance.
• Ensure the power switch is set to [ O ] and turn on at the socket.
• Switch on the Power [ I ]. The current temperature within the appliance is displayed.
• The on the control panel will fl ash for 3-min to indicate a delay between the motor compressor being stopped and then restarted.
Open/close the lid or drawer
WARNING: The sliding lid does not have a locking mechanism. Always make sure that the lid is in the 'half-open' position
before opening.
WARNING: Do not pull the drawer out of its full open position to avoid any hurt.
The lid of the GSA is multi-positional:
• With the lid closed, slide the panel back into the half open position. This allows partial access to the GN container trays.
• Lift the lid up and back so the hinge settles into the support slot.
• Lift the lid up and completely back so the GN container trays are co mpletely exposed.
Temperature setting and control(DIXELL)
The front panel of the thermostat
1. Defrosting light
2. Compressor operation light
3. Digital thermostat
4. Programming key (Service agent only)
5. Temperature modifi cation keys
6. Manual defrost
How to see the set point
• Push and immediately release the SET key, the set point will be showed;
• Push and immediately release the SET key again or wait about 15s to return to normal visualisation.
How to change the set point
• Push the SET key for more than 2 seconds to change the set point value;
• The value of the set point will be displayed and the " °C " starts blinking;
• To change the set value push the „ " (up) or „ " (down) arrows within 15s.
• To memorise the new set point value push the SET key again or wait 15s.
Automatic defrost
The appliance will automatically run defrost cycles.
Note: The cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
• Press and hold the DEFROST
• The defrost cycle will start immediately and the Defrost LED illuminates.
Note: Starting a manual defrost also resets the automatic defrost timer. The next automatic defrost will start according
to the set parameter after the manual defrost has finished.
button for 5 seconds.
6
GB