Publicidad
Idiomas disponibles
Idiomas disponibles
Children should not play with the product.
Before carrying out any maintenance work, or during
long periods without use, make sure that the device
has been disconnected from the mains.
Do not clean the product while it is working and do not
immerse it in water.
Do not handle the heater with wet hands.
Do not coil the power cable around or on top of the
product while it is working.
If the cable gets damaged it must be replaced by S&P
– take the equipment to our official S&P because the
work must be done by specialist personnel to avoid
any risk of damage.
The heater must always work vertically, with the
controls at the top and the base located on a stable
surface.
Only for internal use.
2.
The product
Description of the product (Figure 1):
A
Outlet air
B
Thermostat
C
Power selector
D
LED
E
Transport handle
F
Inlet air
G
Safety tilt switch
3.
Use and operation
Make sure the power supply corresponds to the details shown on the nameplate:
230 V ~ 50Hz.
Before connecting the product to the power, make sure that it is located on a stable floor
and has a firm vertical position. Remember that as a safety feature, the product
incorporates a safety tilt switch under the base (Fig.1 G)
10
Publicidad
