Publicidad
Idiomas disponibles
Idiomas disponibles
Electric connection____________________
Before doing manipulations inside the device, it should be disconnected of the electric supply.
The Speedcenter is suppliedfrom the Speedmatic´s communication cables, therefore the connections will be carried
out following the indications of diagram 2 using H03 cable 4G0.5 mm with total length less than 20 m.
Alarm monitoring: the Speedcenter has a volt-free contact with 1 A of maximum intensity for the transmission of
diferent types of signal (optical, acoustics, etc) when detects some failure that previously has been displayed in the
LCD screen. For its connection to see Fig. 2.
Control panel____________________________________________________
7
1- LCD screen. Shows the set pressure in operating mode.
2- AUTO pushbutton . It allows to change from AUTOMATIC to transition mode or vice versa. In manual mode the
AUTOMATIC led light is lit.
3- START-STOP pushbutton. Use it for switching from transition mode to manual mode. In manual mode it starts and stops
the previously selected pump by mean of the push-buttons pq (5).
4- MENU pushbutton. Use it to enter or to leave the configuration menu. Also to leave the manual mode.
5- Pushbuttons for changing configuration data showed in the LCD screen and for selecting the pump in manual mode.
6- ENTER pushbutton. Use it for saving programmed values. Every pulsation is succeeded by a new field of the
CONFIGURATION MENU. Whenever we want to quit the configuration sequence press MENU (4).
7- Led lights:
• LINE (green): electric supply. Bright when it is connected.
• FAILURE (red): bright or intermittent depending on type of failure.
• PUMP (yellow): when it is bright it means there is at least a pump operating. It is lit with all the pumps stopped or
when the device is not connected.
• AUTOMATIC (green): bright in automatic mode, lit in manual and transition mode.
Configuration____________________________________________________
Before proceeding to the Speedcenter configuration it must be verified the installation of each Speedmatic by
following the steps described in the users manual of the Speedmatic - CONFIGURATION section. A correct
installation implies:
- Max. current intensity selection for each pump.
- Rotation sense verification for each pump.
- Minimum speed selection for each pump.
- Set all the devices as SWITCHER (Speedmatic´s booklet / configuration / step 12 / serial control: master, slave
All the values are changed using pq and pressing ENTER to memorize changes. After each ENTER, there will be
showed consecutively the different screens that constitute the configuration sequence. We can escape from the
configuration sequence by pressing MENU, being saved the data modified until this step.
Please follow next steps:
6
3
or switcher).
Press MENU to start the configuration sequence.
______________________________
2
-3-
Publicidad
