Installing The Ceiling Fan; Assembling The Blade Holders (J); Installing The Extension Rod (B) - Kompernaß KH 1150 Instrucciones De Uso

6

Installing the Ceiling Fan

Warning:
Follow the safety instructions (see Section 1) to avoid injuries or damage
as a result of installation errors. Do not use the fan if it is damaged.
NOTE:
The letters in parentheses refer to the figure in Section 3
"Product Overview".
Required Tools
Phillips head screwdriver
Open-jawed spanner 8 mm

6.1 Assembling the blade holders (J)

1 Select the desired decor: wood grain or white surface. Lay out the
blades so that the desired decor faces down.
2 Run the lock pins of a blade mount (J) through the 3 openings of a blade
(H) from below. Position the blade attachment (I) and push in the direction of
the arrow (see Fig.). The spring clip must snap in and secure the middle
pin (see Fig.: circle). Mount all blades in the same way.
H
I

6.2 Installing the Extension Rod (B)

1a Long rod with plastic mount:
Step 1: Loosen the side locking pin on the extension rod (see Fig., circle).
Step 2: Slide the mount downward until the lock pin is exposed.
Step 3: Pull out the lock pin.
1
2
1b If you would like to use the short extension rod, pull the mount entirely
2 Step 1: Loosen the side screws of the connector (C) so that the extension
J
Damaged cables lead to short-circuits. In such cases, touching
the fan could be life-threatening!
During the following insertion do not damage the bolts in the
extension rods and the cable connection piece!
3 Pull the cable through the casing and place the casing onto the
motor housing over the connector.
3
4a Step 1: Longer extension rod: Pull the cable through, then insert the
- 19 -
off the long rod and slide it about halfway onto the short rod, as shown.
rod can be inserted.
Step 2: Remove the pins of the connector: Pull out the linch pin.
Step 3: Remove the pin.
2
3
1
DANGER :
extension rod into the connection piece.
Step 2: Install the safety bolt on the connecting piece.
Step 3: Insert the linch pin.
Step 4: First tighten both screws evenly at the same time until hand-tight,
then screw them in tightly with the screwdriver. Turn the nuts firmly
against the connecting piece (counter).
C