tomado TFW0301G Instrucciones De Uso página 15

• Do not use if it is folded or crumpled.
• Do not use when wet.
• Only use the foot warmer in combination with the switch indicated
on the label.
• Under certain conditions, the electric and magnetic fields transmitted
by the foot warmer could affect the operation of your pacemaker.
However, the radiation values are far below the limit values: electric
field strength: max. 5000 V/m, magnetic field strength: max. 80 A/m,
magnetic flux density: max. 0.1 millitesla. Therefore, contact your
physician or the manufacturer of your pacemaker prior to using
the foot warmer.
• Do not pull, twist or sharply fold the cords.
• Regularly check the foot warmer for signs of wear and tear or damage.
If there are signs of wear and tear, or if the foot warmer has not been
used as intended, or the foot warmer no longer gets warm, have
the foot warmer checked by the manufacturer prior to use.
• Do not open the appliance or repair it yourself under any
circumstances. If you do, a fault-free operation can no longer be
guaranteed. If you do not observe this instruction, the warranty will
become invalid.
• If the power cord of the appliance is damaged, it should be removed.
If it is not possible to disconnect the power cord from the appliance,
the entire appliance should be disposed of.
• When the foot warmer is switched on,
– no sharp object may be placed on it,
– no heat sources such as hot water bottles, heating pads, etc.,
should be placed on it.
• The electronic components in the switch become warm when using
the foot warmer. When switched on, the switch may not be covered
or placed on the foot warmer.
• Observe the instructions in the following chapters at all times:
Operation, Cleaning and maintenance, Storage.
• If you have any questions about using our appliance, please contact
our customer service.
EN - 15