Peaq PDR300-W Manual De Instrucciones página 48

ENGLISH
dripping or splashing and no objects
filled with liquids, such as vases, shall be
placed on the product.
• Care should be taken so that no objects
or liquids enter the enclosure through
openings.
• No naked flame sources, such as lighted
candles, should be placed on the prod-
uct.
• Refer all servicing to authorised service
agent. Do not attempt to repair the prod-
uct yourself. Servicing is required when
the product has been damaged in any
way, such as the supply cord or plug are
damaged, liquid has been spilled, objects
have fallen into the product, the enclo-
sure is damaged, the product has been
exposed to rain or moisture, does not op-
erate normally, or has been dropped.
• Before connecting the product to a sock-
et outlet, make sure the voltage indicated
on the product corresponds to your local
mains.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its ser-
vice agent or similarly qualified person in
order to avoid hazard.
• Regularly check if the supply cord, prod-
uct or extension cable is defective. If
found defective, do not put the product
into operation. Immediately pull the plug.
• Place the supply cord and, if necessary,
an appropriate extension cable in such
away that pulling or tripping over it is im-
possible. Do not allow the supply cord to
hang down within easy reach.
• Do not jam, bend or pull the supply cord
over sharp edges.
• Only use the provided adaptor.
• The adaptor power plug is used as the
disconnect device; the disconnect device
shall remain readily operable. To com-
pletely disconnect the power input, dis-
connect the adaptor power plug.
• The product may not function properly or
not react to the operation of any control
due to electrostatic discharge. Switch off
and disconnect the appliance; reconnect
48
PDR300_IM_I_06.indb 48 b1
after a few seconds.
• Protect the supply cord from being
walked on or pinched particularly at the
plug, convenience receptacles and the
point where it exits from the product.
• Never pull the adaptor power plug by the
supply cord or with wet hands.
• Disconnect the adaptor power plug in
case of faults during use, during lighten-
ing storms, before cleaning and when not
using the product for a longer period of
time.
• Danger! Before cleaning, switch the
product off and disconnect the adaptor
power plug from the socket.
• When the product has reached the end
of its service life, make it defective by dis-
connecting the adaptor power plug from
the socket and cutting the cord in two.
7/23/13 4:50 PM