Shaft Assembly; Auxiliary Handle Assembly; Cutting Line - Weed Eater WE20VT Manual De Instrucciones

SHAFT ASSEMBLY

1. Align lower tube groove with the
groove inside the upper locking sleeve
assembly. Push tubes together until they
snap into place.
Lower Tube Groove
Upper Locking Sleeve Assembly
2. Try to pull tubes back apart. If the tubes
do not come apart, they are properly
snapped into place. If the tubes come
apart, repeat step 1 and push until the
tubes snap into place.
3. Slide lower locking sleeve assembly
over upper locking sleeve assembly and
tighten by turning clockwise.
Lower Locking
Sleeve Assembly
ASSEMBLY
Upper Locking
Sleeve Assembly
9

AUXILIARY HANDLE ASSEMBLY

1. Position auxiliary handle (1) onto the
upper portion of the trimmer shaft.
2. Once the auxiliary handle is in the
desired location, tighten the knob (2)
until locked into position.
3. Before operating the string trimmer,
make sure the auxiliary handle (1) is
tightly locked into position
4. Turn the auxiliary handle adjustment
knob (2) clockwise to lock the handle
securely into position.
1
WARNING:
the auxiliary handle for optimum control and
balance. Do not overreach when operating
the string trimmer. Keep proper balance
at all times for better control of the tool in
unexpected situations.

CUTTING LINE

A pre-wound spool is pre-installed on the
string trimmer. When the cutting line needs to
be replaced, insert a new spool.
2
To avoid injury, adjust