Ferplast chef pro Manual De Uso página 9

Ocultar thumbs Ver también para chef pro:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
• If the batteries leak, please take them away immediately.
• In order to maintain the feeder settings when changing batteries, make sure that
you replace the batteries within  minutes.
• Although batteries can power the feeder for a long period of time, we recommend
replacing them before long periods of absence.
• Always replace the batteries when the relative red LED flashes slowly.
• Flat batteries should be disposed of in specific battery disposal containers.
• Place the feeder at a distance of 2.5 cm at least from the front panel (fig. A), in
order to ensure a perfect opening of the front door.
• Do not place the feeder in areas subject to splashes of water or high levels of
relative humidity.
• Do not pack too much food into the feeder (especially in the case of fine granular
food).
• This feeder is not designed for underwater use.
• The CHEF PRO feeder can be integrated into CAYMAN or STAR aquariums. (in the
CAYMAN aquarium, once the feeder is in position, we recommend leaving the
compartment door open for greater efficiency and better ventilation).
PROGRAMMING (FIG. B)
• P1 / P2 / P3
Programming daily feeding sessions (up to  feeding sessions per day).
I.e.: it's 8 a.m. and you press the P1 button, the feeder will supply one food session
daily at 8 a.m. The same with the P2 and P3 buttons. If both LEDS are on at the same
time, the feeder has not yet been programmed.
• +2 h
Regulation of the period of time between the programming time and the time of the
first, second or third feeding session to be set:after pressing this button several times
(on the basis of the desired interval), press P1, P2 or P3 within  seconds (the yellow
LED will flash quickly during this period). Once programming has been completed, the
yellow LED will flash for as many times as the +2h button was pressed, allowing you to
ensure that you programmed it correctly.
I.e.: it's 8 a.m. and you want to set  daily feeding sessions, one at midday and one
at 6 p.m.:
- press the +2h button twice;
- Press the P1 button within  seconds (the yellow LED will flash twice,
indicating a  hour time interval from the current time);
- Press the +2h button  times;
- Press the P2 button within  seconds (the yellow LED will flash  times,
indicating a 0 hour time interval from the current time).
• P1 + P3
Putting the feeder in STAND-BY (the food will only be supplied by pressing the MANUAL
button); to reactivate the previous programme, press these two buttons again at the
same time.
IT
EN
FR
D
NL
ES
SK
CS
HU
SV
DA
RU
PL


Publicidad

Tabla de contenido
loading

Tabla de contenido