Maintenance; Troubleshooting; Technical Data - Urrea RME1030 Manual De Usuario

1. HAMMER DRILLING
WARNING: Do not use tools without SDSplus
for hammer drilling!
Tools without SDS-plus and their holder and
drill chuck would be damaged by hammer drill-
ing. When working with tool without SDS-plus,
set the operating mode selector knob to posi-
tion " ".
2. CHIPPING AND CHISELING
Before inserting the chisel, set the operating
mode selector knob to the "hammering only"
position.
Insert the appropriate chisel. To adjust the
head of the chisel to the desired angle, set the
operating mode selector knob to the "bit ro-
tation" position and rotate the chisel by
hand. Return the mode selector to the "ham-
mering only" position.
· Adjust the auxiliary handle as required.
· Start on the trigger of tool and start working.
Hold the tool firmly with both hands, turn the
tool on and apply slight pressure on the tool so
that the tool will not bounce around, uncon-
trolled. Pressing very hard on the tool will not
increase the efficiency.

MAINTENANCE

WARNING: Before all care and maintenance
work:
• Turn the machine off.
• Wait until the machine has come to a com-
plete standstill.
• Pull out the power plug.
1. Avoid the tool vibration or impact, and keep
it from oil and grease.
2. Inspect bolts periodically. If the bolts loosen,
tighten them immediately, or will result in seri-
ous accident.
3. Inspect tool cords periodically. If damaged,
have repaired at your nearest Authorized Ser-
vice Center.
4. Keep the vents clean. Clean all parts of the
tool, clean dust periodically. To prevent debris
entry.
5. Change the brush. Inspect and change the
brush by Authorized Service Center to ensure
safety operation and long use life.
6. All service MUST only be performed by Au-
thorized Service Center. ALWAYS use only ac-
E N G L I S H •
cessories that are recommended for this tool.
In this instruction has not mentioned the parts,
please be passing through authorized the ser-
vice center replacement!
7. Cleanliness. Avoid the use of plastic cracks
caused by damage to the solvent. Use clean cloths
and mild soap to clean the plastic housing.
WARNING: Do not allow the water enter
the motor and the tool full immersed in the
ware, which will result in motor malfunction
and electric shock.

TROUBLESHOOTING

Motor stops running
• Unconnected to power source. Connect to
power source.
• Plugs not fully connect. Check all plugs.
• Switch out of work. Replace or repair the switch.
• Brushes not touch the commutator. Replace
the brush with a new one.
Drill bit doesn't rotate
• Operating mode selector knob not engaged.
After rotation has stopped, move the operat-
ing mode selector knob until it engages.
No hammering action and the tool wobbles
• Operating mode selector knob set to rotary
drilling. Set operating mode selector knob to
hammer drilling.

TECHNICAL DATA

VOLTAGE-FREQUENCY
SPEED
IMPACTS PER MINUTE
IMPACT ENERGY
CHUCK
POWER
WEIGHT
U se r's m a n ua l
120 V ~ 60 Hz
(0 - 850) r/min
0 - 3 700
4,5 J
SDS PLUS
900 W
4,1 kg
13