Roadstar CLR-700QI Manual De Instrucciones página 5

PRESETS
1. Tune the desired station as explained above;
2. Press and hold [PRESET] button (1) until "P" and the number will flash;
3. Press the [TUNE- / TUNE+] buttons (2/3) to choose the number;
4. Press the [PRESET] button (1) to save the radio station.
STORE RADIO STATIONS AUTOMATICALLY:
Press & Hold the [SCAN] button (4) (for 3 seconds) and the radio will automatically
scan the radio. During the scanning process, the radio will save the scanned stations
sequentially into the memory.
RECALL A PRESET STATION:
Press the [PRESET] button (1) and then choose the number of the preset by pressing
the [TUNE- / TUNE+] buttons (2/3).
ALARM SETTING
When the radio is OFF:
1. Press and hold the [ALARM] button (5 or 6);
2. Use the [HOUR] button (2) to adjust the hour;
3. Use the [MIN] button (3) to adjust the minutes;
4. Confirm with the [ALARM] button (5 or 6);
5. Use the [HOUR] button (2) to choose the alarm mode (Buzzer or radio);
6. Confirm with the [ALARM] button (5 or 6);
7. Use the [TUNE- / TUNE+] (2/3) to adjust the volume;
8. Confirm with the [ALARM] button (5 or 6).
Note: To set the second Alarm, repeat all the steps with "Alarm2" (6) instead of
"Alarm1" (5).
ALARM OFF:
During Alarm on, press [ALARM OFF] button (7) to deactivate the alarm or press
[SNOOZE] button (4) to postpone the alarm for 9 minutes.
ACTIVATE / DEACTIVATE ALARM SETTINGS:
In stand-by, press the [ALARM] button (5 or 6) to activate / deactivate the alarm (the
alarm icon will appear / disappear).
SLEEP TIMER
The sleep timer switches the radio off automatically after an adjustable time.
When the radio is ON press repeatedly the [SLEEP] (4) to choose the desired timer.
Note: To remove the sleep timer select "OFF".
QI ENABLED - SMARTPHONE CHARGING
Place your Qi enabled smartphone on the center of the wireless charging pad.
Please check if your phone screen shows charging status.
If your phone is not charging:
Check if your device supports Qi wireless charging
•
Place mobile device in center
•
Remove the case with magnet, metal, or thicker material than 0.12''(3mm)
•
Note: Charges through most cases of Polycarbonate (PC) or Thermoplastic Polyure-
thane (TPU) material up to 0.12''(3mm). Compatibility (Qi Wireless Charging Pad).
English 2