Publicidad
Idiomas disponibles
Idiomas disponibles
Position the plates for best fit inside the tracks.
-OR-
NOTE:
If screws seem too short and are not
engaging the plate, take out screw,
remove plastic spacer, use washer only.
For deeper tracks you may need to use
the longer screws (M6x40) supplied with
the D plates.
In some cases, it may be easier to
assemble plates, screws, and bases
before sliding onto tracks.
Arrange Landing Pads on the tracks in the approximate
positions where Control Towers will be attached.
YOu aRE NOW REaDY TO PROCEED TO CONTROL TOWER iNSTRuCTiONS.
1033575B-2/6
NOTE: The "D" plate is
for use on larger tracks. If
the"D" plate is too wide for
your tracks, use the"C" plate.
Replace end caps.
Do not fully tighten.
Final adjustments will
be made after Control
Install screw with spacer
and washer into pad.
Engage the screw with wrench supplied. Do not fully tighten.
Consider where the most
convenient placement of
your load would be before
completing the installation.
NOTE:
Tower is installed.
Align screws in Landing
Pads with plates.
CROSSBaR SPREaD:
The distance between the Yakima
crossbars is determined by the
accessories you wish to carry.
The Crossbar Spread Table (Fit List or
Catalog) will tell you how much crossbar
spread your accessories require.
Publicidad
