Publicidad
EN
ENGLISH
Mounting steps: Page 7 – 10
The lights can only be mounted in
an upright position.
The lights must not vibrate or jut
out above the bonnet, and must be
mounted symmetrically. Determine
the mounting position and mark the
fastening points.
Drill using a 3 mm drill bit, and drill
out to 11 mm. Seal drilled metal
22
parts with rust protection.
When fitting the lights, Ensure that
the light is mounted horizontally.
Align the light in accordance with
the drawing and tighten the screws.
Lay and connect the cables in ac-
cordance with the circuit diagram.
(Page 16, 17, 18, 19)
According to circuit diagram A, the
driving lights are switched on to-
gether with the existing spotlights.
According to circuit diagram B, the
auxiliary lights are switched on in
addition to the existing headlights
via a separate switch.
It is however essential that
country-specific laws and state
regulations are observed.
Check the lighting system, fasten
the connection cables securely.
Have the driving lights adjusted
at a specialist garage.
Only correctly adjusted lights
provide optimum light.
Electrical connection:
page 13
Fit the relay with the connection
terminals pointing downwards in a
waterproof manner. If required and
if legally permitted, fit a switch in
the dashboard.
A useful tip:
Keep the cover lenses clean. Dirt
may absorb up to 80% of the light
emitted.
Publicidad
