Closing The Door; Installation; Electrical Connection - AEG AGS58800S0 Manual De Instrucciones

12 www.aeg.com
Problem
The temperature in
the freezer is too
high.
There is too much
frost.

6.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
3.
Cli-
mate
class
SN
N
ST
T

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
Solution
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C