Installation; Installing The Customer Hardware - Rittal TS IT Pro 9982.200 Instrucciones De Montaje

6. Installation

6. Installation
6. Instalación
6. Installation

6.1 Installing the customer hardware

The loads of the installed equipment and the
maximum admissible payload of the TS IT Pro
must be observed. Also, when using installa-
tion accessories, please observe the specifi ed
load capacity.
Check the 482.6 mm (19˝) distances between
levels and make corrections where necessary
(see page 22 – 23).
The installation of equipment must conform
with the relevant provisions on the installed
equipment. Before confi guring the TS IT Pro,
please determine the positions of all compo-
nents. The factors of the relevant components,
such as weight, accessibility and the require-
ments placed on the power supply, tempera-
ture and air circulation, aff ect the sequence
and location of component positioning in the
rack.
TS IT Pro enclosure system / Baies TS IT Pro / Sistema de racks TS IT Pro
Installation examples:
Exemples d'installation :
Ejemplos de instalación:
Slide rail, depth-variable
Glissière réglable en profondeur
Guía deslizante,
variable en profundidad
◾ Always place the heaviest components at
the bottom of the TS IT Pro. This will help to
increase stability.
◾ Always ensure the correct fastening and
safe positioning of all components and rack
assemblies. Please also observe the torque
information (M ) for the screw connections.
A
◾ Preinstalled TS IT Pro on castors may only
be moved if the centre of gravity of the
installation is below the 15th rack height unit
from the bottom.
◾ At least two persons are required to assem-
ble and dismantle assemblies or compo-
nents weighing more than 55 lbs/25 kg.
◾ Only use safe electrical devices; this unit is
not designed as a Class 1 enclosure.
◾ Only use approved, safe terminal equipment
intended for mounting on 482.6 mm (19˝)
mounting angles or for rack installation using
other equipment (slide rails, component
shelves).
◾ Additional installation weights on doors or
side panels are not permitted.
482.6 mm (19˝) component shelf,
telescopic
Tablette d'appareillage 19˝
télescopique
Bandeja para aparatos de 19˝,
telescópica
◾ Caution when using telescopic slides:
The TS IT Pro must be secured to the
fl oor or bayed with other TS IT Pro before
extending equipment on telescopic slides.
Only one device at a time may be in the set
forward position. If for some reason more
than one device is extended at the same
time, the stability of the TS IT Pro may be
at risk.
Failure to follow these instructions may lead to
serious injury, damage to property or, in the
worst case, even death.
27