Tamper-Resistant Screw; How To Assemble; How To Use; Care And Cleaning - VOX electronics ES-8102 ALB Manual De Usuario

TAMPeR-ReSISTANT SCReW

This appliance is equipped with a tamper-resistant screw to prevent removal of the bottom cover. To
reduce the risk of fire or electric shock, do not attempt to remove the bottom cover. There are no user
serviceable parts inside. Repair should be done only by authorized service personnel.

HoW To ASSeMBle

Before first use: unclamp the Lock Cover and carefully disassemble and wash the plunger, Top Cover,
Filtrate Toil (CAUTION:"teeth" are sharp), Segregator, Pulp container and juice cup in soapy water.
Rinse and dry. Never immerse the motor unit wipe it with a damp sponge or cloth.
1. Fit the Segregator onto the motor unit.
2. Sit the Filtrate Toil into the hole of the Segregator. When properly "seated", it should spin easily.
3. Fit the Top Cover onto the Segregator.
4. Raise the Lock Cover and fit the Tab of each Latch into the Groove on each side of the Top Cover.
Press the bottom of each Latch to lock it in place. The unit will not operate unless the 2 safety
Locking Latches are securely clamped.
5. Position the Juice Cup under the Segregator spout so that the handle faces out.

HoW To USe

1. Prepare the fruit or vegetables to be processed by washing, peeling, pitting, and cutting them as
needed to fit into the Chute.
2. Plug the cord into a standard 220-240 volt AC outlet.
3. Be sure the Juice Cup is all the way under the Segregator spout so that processed juice will flow
from the spout into the Cup. The Lock Cover must be clamped down or the Juice Extractor will not
operate.
4. Turning Switch to speed 1 or speed 2 .
5. Place food into the Feeder Tube and press down with the plunger. Never use your fingers to push
the food down. Food can be continuously fed into the Feeder Tube without turning off the unit.
6. When you're finished juicing or the Segregator or Juice Cup are full, turn the unit "off". Unplug the
unit.

CARe ANd CleANING

NOTE: To prolong the life of the unit, always clean all washable parts after every use.
1. Be sure the unit is "off" and unplugged before cleaning any part.
2. Unclamp the Lock Cover and remove the Top Cover, plunger, Filtrate Toil (be careful with the
"teeth"), and Segregator. You may discard or compost the pulp from the Segregator.
3. Wash the Top Cover, plunger, Filtrate Toil, and Segregator, Pulp Container in hot, soapy water.
These parts are not dishwasher-safe. The Filtrate Toil teeth are very sharp—handle carefully. Use a
bristle brush to remove fine pulp that may remain. Rinse, dry, and reassemble the unit for storage.
NOTE: Over time, parts may discolor (especially from juicing carrots).
3