VOX electronics SMX-3110 Manual De Usuario página 6

4. Turn the switch knob to 0 position and put the mixture into the bowl or other
objects,and then plug in the power supply socket.（See Fig.5）
5. Put the two holes below the right body into the two buttons on the engine
base and pull back a little bit hard, and then press down the backend. Once
heard a clicking, the third button placement has been completely buck-
led.（See Fig.6）
6. Turn the speed selector to your desired setting. The appliance will start work-
ing and the speed will achieve the highest speed if the Turbo Switch depressed
at any time except at the 0 position.
7. The max operation time per time shall not exceed 5 minutes and minimum
10 minutes rest time must be maintained between two consecutive cycles.
8. When kneading yeast dough, suggest the speed selector first use a low
speed and then use high speed to achieve the best results.
9. Uniform effect can be achieved only when the bowl is in the case of move-
ment. 10. When mixing is completed, turn the speed selector to 0 position, un-
plug the cord from power outlet.
11. Pushing the lock button on the back of tray, and raise up the hand mixer, so
that you can separate the hand mixer from the base. （See Fig.7）
12. If necessary you can scrape the excess food particles from the beaters or
dough hooks by rubber or wooden spatula.
13.Only when turning the speed selector to 0 position, and pushing the Ejector
button at the same time, can the beater or dough hooks eject. （See Fig.8）
14. When adding the food into a plastic bowl, the food at least need to reach
the lowest scale line of the bowl, in order to make sure the agitator can fully
stir the food (See Fig. 9)
:
CAUSION
1）Food adding, scraper ,etc. will be allowed after turning off the moving mixer
and removing the main unit by pressing the lock button.
2）In a separate operation, please do not let high-speed beaters or hooks are
to others as this would cause injury.