Risk To Breathing; Risk From Moving Parts - DeWalt D55143 Manual De Instrucciones

K GROUNDED L
OUTLET
BOX
GROUNDING PIN
D WALT does not recommend the use of extension cords for
E
any air compressor. This can create power loss and overheating
of the motor. Use an additional air hose rather than an extension
cord. If use of an extension cord is unavoidable, it should be
plugged into a GFCI found in circuit boxes or protected receptacles.
When using an extension cord, observe the following.
Extension Cord Chart
Motor
Rating Length of Cord in Feet
25' (7.6m)
12 amp, 120V 14 Ga.
Motor
Rating Length of Cord in Feet
25' (7.6m)
15 amp, 120V 14 Ga.
REPAIR OR REPLACE DAMAGED OR WORN CORDS
IMMEDIATELY.
RISK FROM FLYING OBJECTS
The compressed air stream can cause soft tissue damage to
exposed skin and can propel dirt, chips, loose particles and small
objects at high speed, resulting in serious injury. Always wear ANSI
Z87.1 approved safety glasses with side shields when using the
compressor. Never direct air stream at people or animals. Use only
OSHA approved air blow guns.
M
GROUNDING
MEANS
ADAPTER
50' (15.2m) 100' (30.5m)
12 Ga. 10 Ga.
50' (15.2m) 100' (30.5m)
12 Ga. 8 Ga.

RISK TO BREATHING

The compressed air from your compressor is not safe
for breathing! The air stream may contain carbon
monoxide, toxic vapors or solid particles. Never
inhale air from the compressor either directly or from
a breathing device connected to the compressor.
Sprayed materials such as paint, paint solvents, paint remover,
insecticides, weed killers, etc. contain harmful vapors and poisons.
NOTE: Operate air compressor only in a well ventilated area. Read
and follow the safety instructions provided on the label or safety
data sheets for the material you are spraying. Use a NIOSH/OSHA
approved respirator designed for use with specific application.

RISK FROM MOVING PARTS

The compressor cycles automatically when the
pressure switch is in the ON position. Always turn
off the compressor, bleed pressure from the air
hose and tank, and disconnect from power
source before performing maintenance or attach-
ing tools and accessories.
Keep your hair, clothing and gloves away from moving parts.
Loose clothes, jewelry or long hair can be caught in moving parts.
Air vents may cover moving parts and should be avoided as well.
Do not remove the protective covers from this product. Never oper-
ate compressor with guards or protective covers that are damaged
or removed.
RISK OF BURNS (FIG. 5)
Touching exposed metal such as the compressor
head or aftercooler can result in serious burns. Never
touch any exposed metal parts on compressor during
or immediately after operation. Compressor will
remain hot for several minutes after operation. Do not
move the compressor while it is running. Hot motor
3