Water Connection - Emerson InSinkErator CWT-00 Manual Del Propietário

These instructions assume instant hot/cool water dispenser faucet, tank
and/or filter has already been installed. Refer to Installation, Care & Use
manual included with hot/cool water dispenser.
Cold Only Faucet
Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
1
PREPARATION
a
Copper Tubing
Blue Tubing
White Tubing
< 18"
Filter
Chilled
Water
Property Damage: Do not place objects Tank
on top of chilled water tank which
could obstruct the fan.
OVERVIEW OF A TYPICAL INSTALLATION with Instant Hot Water Dispenser
Instant Hot/Cool
Water Dispenser Faucet
Copper Tubing
Filter
Air-Activated
SinkTop Switch
Instant
Hot Water
Tank
Note: Chilled water tank must be plugged
directly into open wall outlet.
4
Unplug instant hot water tank and
hold handle in open position until
cool water flows from spout.
Food
Turn off water supply.
Waste
Identify the undersink location for the
Disposer
chilled water tank.
For best performance, allow for a
minimum 2" space around the sides
and top of the chilled water tank.
The chilled water tank will require
a minimum footprint of 15" wide
by 11" deep.
Ensure that there is a minimum
of 18" vertical clearance for the
chilled water tank.
Shown with optional filtration
White Tape
Food
Waste
Disposer
White Tape
Blue Tubing
™
White Tubing
Chilled
Water
Tank
Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
2
INSTALLING THE WATER TANK
a
Property Damage: All tubes must be cut
squarely with no burrs.
b
Air-Activated
SinkTop Switch
White Tape
™
Property Damage: Do not pinch or break tubing.
Do not distort the last 1" of tubing.
Pull on connection to ensure fully engaged.
3

WATER CONNECTION

a
White Tape
To chilled water
tank "Inlet"
To remove tube(s) or plug from quick-connector,
depress the release ring and gently pull away.
Attach supplied quick connect elbow
to end of supplied white 1/4" tube.
Attach quick connect elbow to water
Inlet
Inlet on front of chilled water tank.
Measure distance from water inlet
on chilled water tank to water supply
valve. Carefully trim white 1/4" tube,
allowing ample slack in tubing.
Inlet
Outlet
Attach supplied quick connect elbow
to end of supplied blue 1/4" tube.
Attach quick connect elbow with
Outlet
blue tube to water Outlet on front of
chilled water tank.
Measure distance from the chilled
water tank outlet to water supply line
on faucet. Carefully trim blue tube to
correct length.
Using quick connect elbow, connect
remaining end of blue tube to unmarked
copper tube coming from faucet.
Remove existing "Y" quick-connect
fitting and discard.
To hot water
dispenser
Connect white 3/8" tube from
the filter or water supply into the
supplied "Y" quick-connect fitting
until it stops.
Insert 1/4" white tube from
From filter or
tank inlet into the 3/8" to 1/4"
water supply
quick-connect fitting.
Identify copper HOT water tube,
which is marked with white tape.
Install that tube into the 3/8" to 1/4"
quick-connect fitting.
5